| Surface roughness | Rtmax | Ra |
| Sliding surface | ≤ 2.5 µm | 0.1–0.5 µm |
| Trough bottom | ≤ 6.3 µm | ≤ 1.6 µm |
| Trough side | ≤ 15 µm | ≤ 3 µm |
| Bearing area: 50-95% and 0.5 Rz cutting depth (based on Cref = 0%) | ||
| Recommended size mm | |||||
| d* | D/H9 | L / +0.2 | Rmax | s | |
| ＞ | ≤ | ||||
| 21 | 22 | d + 8 | 6.5 | 0.2 | e8/H9 |
| 22 | 36 | d + 10 | 8 | 0.2 | e8/H9 |
| 36 | 56 | d + 12 | 8 | 0.2 | e8/H9 |
| 56 | 85 | d + 15 | 11 | 0.2 | f7/H7 |
| 85 | 140 | d + 20 | 13 | 0.2 | f7/H7 |
| 140 | 200 | d + 25 | 16 | 0.2 | f7/H7 |
| 200 | 300 | d + 30 | 19 | 0.2 | f7/H7 |
| 300 | d + 40 | 26 | 0.2 | f7/H7 | |
| The extrusion gap values shown in the table above apply to temperatures below 70 °C. Higher temperatures require lower extrusion gaps. | |||||
| Operating parameters | |||||
| Material | Temperature | Speed | Pressure | ||
| Sealing components | Retaining ring | Minimum °C | Maximum °C | Maximum m/s | Maximum bar (MPa) |
 PU |
|
-30 | +100 | 0.2 | 400 (40) |
 HPU |
-20 | 0.3 | |||
 SPU |
-40 | ||||
 TPU |
-20 | 0.2 | |||
POM| Ordering example | |
| Introduction | Rotary seal TR03-P |
| d x D x L [mm] | 100 x 120 x 13 |
| Sealing material | PU / POM |
Product classification
Label List
Previous Page
TR03-R
Next Page
Free inquiry
