| Sealing material | TPU | PTEF | ||
| Surface roughness | Rtmax | Ra | Rtmax | Ra |
| Sliding surface | ≤ 2.5 µm | 0.1–0.5 µm | ≤2 µm | 0.05–0.3 µm |
| Groove bottom | ≤ 6.3 µm | ≤ 1.6 µm | ≤6.3 µm | ≤ 1.6 µm |
| Groove side | ≤ 15 µm | ≤ 3 µm | ≤15 µm | ≤ 3 µm |
| Bearing area: 50-95% and 0.5 Rz cutting depth (based on Cref = 0%) | ||||
| Recommended size mm | |||||
| D/H9 | d1)/h10 | d1/h8 | L/+0.2 | L1/+0.2 | |
| > | ≤ | > | |||
| 20 | 50 | D - 10 | D - 3 | 6.5 | 4 |
| 50 | 80 | D - 15 | D - 4 | 8 | 4 |
| 80 | 150 | D - 20 | D - 5 | 10.5 | 5.5 |
| 150 | 400 | D - 25 | D - 6 | 13.4 | 7 |
| 400 | 750 | D - 30 | D - 8 | 14.2 | 7 |
| 750 | D - 40 | D - 8 | 15 | 7 | |
| Basic version: >0 with cutting clearance does not allow any support function. For support function, cutting clearance = 0 and helical groove are used. 1)The cross-section usually depends on the profile of the seal. The value of the cutting clearance depends on the material and temperature. Please refer to the profile description for details. |
|||||
| Operating parameters | |||||
| Material | Temperature | Speed | Specific load | ||
| Guide component | Minimum °C | Maximum °C | Maximum m/s | Maximum N/mm2 | |
 PTFE g |
-200 | +200 | 4 | 3.0 | |
 PTFE b |
5 | 4.5 | |||
 POM |
-50 | +100 | 4 | 25 | |
| PA |
-40 |
||||
 Presin |
+130 | 90 | |||
| Ordering example | |
| Introduction | Guide ring TF03 |
| D x d/d1x L/L1[mm] | 100 x 80/95 x 10.5/5.5 |
| Material |
POM |
Previous Page
TF04
Next Page
Free inquiry
