| Surface roughness | Rtmax | Ra |
| Sliding surface | ≤ 2.5 µm | 0.1–0.5 µm |
| Trough bottom | ≤ 6.3 µm | ≤ 1.6 µm |
| Trough side | ≤ 15 µm | ≤ 3 µm |
| Bearing area: 50-95% and 0.5 Rz cutting depth (based on Cref = 0%) | ||
| Recommended Size mm | Maximum gap mm | |||||
| d/f8 | D/H10 | L/+0.2 | Rmax | C | s* | |
| ＞ | ≤ | |||||
| 5 | 25 | d + 8 | 6.3 | 0.4 | 3.5 | 0.33 |
| 25 | 50 | d + 10 | 8.0 | 0.4 | 4.0 | 0.37 |
| 50 | 150 | d + 12 | 9.0 | 0.4 | 5.0 | 0.46 |
| 150 | 300 | d + 16 | 14.0 | 0.4 | 6.0 | 0.54 |
| 300 | 500 | d + 20 | 17.0 | 0.4 | 8.5 | 0.61 |
| 500 | 700 | d + 24 | 25.0 | 0.4 | 10.0 | 0.67 |
| 700 | 1000 | d + 30 | 32.0 | 0.4 | 13.0 | 0.67 |
| 1000 | d + 40 | 32.0 | 0.4 | 13.0 | 0.67 | |
| The extrusion gap values shown in the table above apply to temperatures below 70°C. Higher temperatures require lower extrusion gaps. | ||||||
| Operating parameters | ||||||
| Material | Temperature | Speed | Pressure | |||
| Sealing components | Minimum °C | Maximum °C | Maximum m/s | Maximum bar (MPa) | ||
 PU |
-30 | +110 | 1 | 25 (2.5) | ||
 HPU |
-20 | |||||
 SPU |
2 | |||||
 TPU |
-50 | 1 | ||||
| Ordering example | |
| Introduction | Rod seal TS05-P |
| d x D x L [mm] | 100 x 112 x 10 |
| Sealing material | PU |
Product classification
Label List
Previous Page
TS05-R
Next Page
Free inquiry
