| Surface roughness | Rtmax | Ra |
| Sliding surface | ≤ 2.5 µm | 0.1–0.5 µm |
| Trough bottom | ≤ 6.3 µm | ≤ 1.6 µm |
| Trough side | ≤ 15 µm | ≤ 3 µm |
| Bearing area: 50-95% and 0.5 Rz cutting depth (based on Cref = 0%) | ||
| Recommended Size mm | Maximum gap mm | ||||||||
| d/f8 | D/H10 | L/+0.2 | Rmax | C | s* | ||||
| ＞ | ≤ | 20 bar | 100 bar | 200 bar | 400bar | ||||
| 5 | 25 | d + 8 | 6.3 | 0.4 | 3.5 | 0.33 | 0.17 | 0.11 | 0.05 |
| 25 | 50 | d + 10 | 8.0 | 0.4 | 4.0 | 0.37 | 0.22 | 0.16 | 0.10 |
| 50 | 150 | d + 15 | 10.0 | 0.4 | 5.0 | 0.46 | 0.31 | 0.25 | 0.19 |
| 150 | 300 | d + 20 | 14.0 | 0.4 | 6.0 | 0.54 | 0.39 | 0.32 | 0.26 |
| 300 | 500 | d + 25 | 17.0 | 0.4 | 8.5 | 0.61 | 0.46 | 0.39 | 0.33 |
| 500 | 600 | d + 30 | 25.0 | 0.4 | 10.0 | 0.67 | 0.52 | 0.45 | 0.39 |
| The extrusion gap values shown in the table above are applicable to temperatures below 70°C. Higher temperatures require lower extrusion gaps. | |||||||||
| Operating parameters | ||||||
| Material | Temperature | Speed | Pressure | |||
| Sealing components | Elastomer | Minimum °C | Maximum °C | Maximum m/s | Maximum bar (MPa) | |
 PU |
NBR70 | -30 | +100 | 0.5 | 400 (40) | |
 HPU |
-20 | |||||
 SPU |
0.7 | |||||
 TPU |
MVQ70 | -50 | +110 | 0.5 | ||
| Ordering example | |
| Introduction | Rod seal TS07-P |
| d x D x L [mm] | 100 x 115 x 10 |
| Sealing material | PU/NBR70 |
Product classification
Label List
Previous Page
TS07-F
Next Page
Free inquiry
