| Surface roughness | Rtmax | Ra |
| Sliding surface | ≤ 2 µm | 0.05–0.3 µm |
| Trough bottom | ≤ 6.3 µm | ≤ 1.6 µm |
| Trough side | ≤ 15 µm | ≤ 3 µm |
| Bearing area: 50-95% and 0.5 Rz cutting depth (based on Cref = 0%) | ||
| Recommended Size mm | Maximum gap mm | ||||||
| d/f8 | D/H9 | L/+0.2 | s* | ||||
| ＞ | ≤ | 20 bar | 100 bar | 200 bar | 400 bar | ||
| 20 | 35 | d + 8 | 7.5 | 0.33 | 0.17 | 0.11 | 0.05 |
| 35 | 45 | d +8 | 8.5 | 0.37 | 0.22 | 0.16 | 0.10 |
| 45 | 55 | d + 10 | 11 | 0.37 | 0.22 | 0.16 | 0.10 |
| 55 | 120 | d + 15 | 13 | 0.46 | 0.31 | 0.25 | 0.19 |
| 120 | 320 | d + 20 | 17 | 0.54 | 0.39 | 0.32 | 0.26 |
| 320 | 500 | d + 30 | 21 | 0.61 | 0.46 | 0.39 | 0.33 |
| 500 | d + 40 | 26.5 | 0.67 | 0.52 | 0.45 | 0.39 | |
| The extrusion gap values shown in the table above apply to temperatures below 70°C. Higher temperatures require lower extrusion gaps. |
|||||||
| Operating parameters | |||||
| Material | Temperature | Speed | Pressure | ||
| Seal ring 1 | Seal ring 2 | Minimum °C | Maximum °C | Maximum m/s | Maximum bar (MPa) |
 PU |
 PTEF g |
-30 | +110 | 0.5 | 400 (40) |
 HPU |
 PTEF b |
-20 | |||
 SPU |
 PTEF c |
0.7 | |||
 TPU |
PTEF b |
-50 | 0.5 | ||
| Ordering example | |
| Introduction | Rod seal TS17-E |
| d x D x L [mm] | 100 x 115 x 10 |
| Sealing material | PU/PTEF g |
Product classification
Label List
Previous Page
TS17-P
Next Page
Free inquiry
