| Surface roughness | Rtmax | Ra |
| Sliding surface | ≤ 2.5 µm | 0.1–0.5 µm |
| Groove bottom | ≤ 6.3 µm | ≤ 1.6 µm |
| Groove side | ≤ 15 µm | ≤ 3 µm |
| Bearing area: 50-95% and 0.5 Rz cutting depth (based on Cref = 0%) | ||
| Recommended Size mm | Maximum gap mm | |||||||
| d/f8 | D/H10 | L/+0.2 | Rmax | C | s* | |||
| ＞ | ≤ | 20 bar | 100 bar | 160 bar | ||||
| 11 | 25 | d + 8 | 6.3 | 0.4 | 3.5 | 0.23 | 0.16 | 0.14 |
| 25 | 50 | d + 10 | 8.0 | 0.4 | 4.0 | 0.26 | 0.19 | 0.17 |
| 50 | 150 | d + 15 | 10.0 | 0.4 | 5.0 | 0.31 | 0.24 | 0.22 |
| 150 | 300 | d + 20 | 14.0 | 0.4 | 6.0 | 0.34 | 0.27 | 0.25 |
| 300 | 500 | d + 25 | 17.0 | 0.4 | 8.5 | 0.37 | 0.30 | 0.29 |
| 500 | 700 | d + 30 | 25.0 | 0.4 | 10.0 | 0.40 | 0.34 | 0.32 |
| 700 | d + 40 | 32.0 | 0.4 | 13.0 | 0.40 | 0.34 | 0.32 | |
| The extrusion gap values shown in the table above are applicable to temperatures below 70°C. Higher temperatures require lower extrusion gaps. | ||||||||
| Operating parameters | |||||
| Material | Temperature | Speed | Pressure | ||
| Sealing components | Minimum °C | Maximum °C | Maximum m/s | Maximum bar (MPa) | |
 NBR |
-30 | +110 | 0.5 | 160(16) | |
 FKM |
-20 | +200 | |||
 EPDM |
-50 | +150 | |||
 HNBR |
-25 | ||||
 Aflas |
-10 | +200 | - | - | |
 MVQ |
-60 | 0.5 | 160(16) | ||
| Ordering example | |
| Introduction | Rod seal TS01-R |
| d x D x L [mm] | 100 x 115 x 10 |
| Sealing material | NBR |
Product classification
Label List
Previous Page
TS02-P
Next Page
Free inquiry
