| Surface roughness | Rtmax | Ra |
| Sliding surface | ≤ 2.5 µm | 0.1–0.5 µm |
| Trough bottom | ≤ 6.3 µm | ≤ 1.6 µm |
| Trough side | ≤ 15 µm | ≤ 3 µm |
| Bearing area: 50-95% and 0.5 Rz cutting depth (based on Cref = 0%) | ||
| Recommended Size mm | Maximum gap mm | ||||||||
| d/f8 | D/H10 | L/+0.2 | Rmax | C | s* | ||||
| ＞ | ≤ | 100 bar | 200 bar | 400 bar | 600 bar | ||||
| 4 | 8 | d + 4.9 | 2.2 | 0.4 | 2.5 | 0.30 | 0.20 | 0.15 | 0.05 |
| 8 | 19 | d + 7.3 | 3.2 | 0.6 | 3.5 | 0.40 | 0.25 | 0.15 | 0.05 |
| 19 | 38 | d + 10.7 | 4.2 | 1.0 | 4.5 | 0.40 | 0.25 | 0.20 | 0.10 |
| 38 | 200 | d + 15.1 | 6.3 | 1.3 | 5.0 | 0.50 | 0.30 | 0.20 | 0.10 |
| 200 | 256 | d + 20.5 | 8.1 | 1.8 | 6.0 | 0.60 | 0.35 | 0.25 | 0.15 |
| 256 | 600 | d + 24.0 | 8.1 | 1.8 | 8.0 | 0.60 | 0.35 | 0.25 | 0.15 |
| The extrusion gap values shown in the table above apply to temperatures below 70°C. Higher temperatures require lower extrusion gaps. |
|||||||||
| Operating parameters | |||||
| Material | Temperature | Speed | Pressure | ||
| Sealing components | Minimum °C | Maximum °C | Maximum m/s | Maximum bar (MPa) | |
 PU |
-30 | +100 | 5 | 400 (40) | |
 HPU |
 POM |
-20 | |||
 SPU |
 PA |
7 | |||
 TPU |
-40 | 5 | |||
| Ordering example | |
| Introduction | Rod seal TS02-S |
| d x D x L [mm] | 100 x 115.1 x 6.3 |
| Sealing material/support ring | PU / POM |
Product classification
Label List
Previous Page
TS03-F
Next Page
Free inquiry
