| Surface roughness | Rtmax | Ra |
| Sliding surface | ≤ 2 µm | 0.05–0.3 µm |
| Trough bottom | ≤ 6.3 µm | ≤ 1.6 µm |
| Trough side | ≤ 15 µm | ≤ 3 µm |
| Bearing area: 50-95% and 0.5 Rz cutting depth (based on Cref = 0%) | ||
| Recommended Size mm | Maximum gap mm | ||||||||
| d/f8 | D/H10 | L/+0.2 | Rmax | C | s* | ||||
| ＞ | ≤ | 20 bar | 100 bar | 200 bar | 400 bar | ||||
| 5 | 25 | d + 8 | 6.3 | 0.4 | 3.5 | 0.40 | 0.20 | 0.15 | 0.09 |
| 25 | 50 | d + 10 | 8.0 | 0.4 | 4.0 | 0.45 | 0.22 | 0.17 | 0.10 |
| 50 | 150 | d + 15 | 10.0 | 0.4 | 5.0 | 0.75 | 0.40 | 0.33 | 0.18 |
| 150 | 300 | d + 20 | 14.0 | 0.4 | 6.0 | 0.87 | 0.48 | 0.38 | 0.20 |
| 300 | 500 | d + 25 | 17.0 | 0.4 | 8.5 | 0.87 | 0.48 | 0.38 | 0.20 |
| 500 | 600 | d + 30 | 25.0 | 0.4 | 10.0 | 0.87 | 0.48 | 0.38 | 0.20 |
| The extrusion gap values shown in the table above are applicable to temperatures below 70°C. Higher temperatures require lower extrusion gaps. |
|||||||||
| Operating parameters | |||||
| Material | Temperature | Speed | Pressure | ||
| Sealing components | Elastomer | Minimum °C | Maximum °C | Maximum m/s | Maximum bar (MPa) |
 PTFE v |
MVQ70 |
-55 | +200 | 1.0 | 200 (40) |
 PTFE g |
NBR70 |
-30 | +100 | 400 (40) | |
 PTFE b |
FPM75 |
-20 | +200 | ||
 PTFE c |
EPDM70 |
-50 | +150 | ||
 UHMWPE |
NBR70 |
-30 | +90 | ||
| MVQ70 |
-55 | 0.5 | 200 (40) | ||
| Ordering example | |
| Introduction | Rod seal TS03-F |
| d x D x L [mm] | 100 x 115 x 10 |
| Sealing material | PTFE b / FPM75 |
Product classification
Label List
Previous Page
TS03-P
Next Page
Free inquiry
