| Surface roughness | Rtmax | Ra |
| Sliding surface | ≤ 2.5 µm | 0.1-0.5 µm |
| Trough bottom | ≤ 6.3 µm | ≤ 1.6 µm |
| Trough side | ≤ 15 µm | ≤ 3 µm |
| Bearing area: 50-95% and 0.5 Rz cutting depth (based on Cref = 0%) | ||
| Recommended Size mm | Maximum gap mm | ||||||||
| d/f8 | D/H10 | L/+0.2 | Rmax | C | s* | ||||
| ＞ | ≤ | 100 bar | 200 bar | 400 bar | 600 bar |
||||
| 4 | 50 | d + 10 | 5.0 | 0.2 | 4.0 | 0.50 | 0.40 | 0.30 | 0.20 |
| 50 | 60 | d+15 | 7.5 | 0.3 | 5.0 | 0.50 | 0.40 | 0.30 | 0.20 |
| 60 | 200 | d + 20 | 10.0 | 0.4 | 6.0 | 0.70 | 0.50 | 0.40 | 0.20 |
| 200 | 300 | d + 25 | 12.5 | 0.4 | 8.5 | 0.80 | 0.60 | 0.50 | 0.30 |
| 300 | 530 | d + 30 | 15.0 | 0.8 | 10.0 | 0.90 | 0.70 | 0.60 | 0.30 |
| 530 | 680 | d + 35 | 17.5 | 1.2 | 11.5 | 1.00 | 0.80 | 0.70 | 0.30 |
| 680 | 1500 | d + 40 | 20.0 | 1.2 | 13.0 | 1.10 | 0.90 | 0.80 | 0.40 |
| The extrusion gap values shown in the table above are applicable to temperatures below 70°C. Higher temperatures require a lower extrusion gap. | |||||||||
0
| Operating parameters | ||||||
| Material | Temperature | Speed | Pressure | |||
| Sealing components | Elastomer | Minimum °C | Maximum °C | Maximum m/s | Maximum bar (MPa) | |
 XHPU |
 NBR |
-30 | +100 | 5 | 600 (60) |
|
 XSPU |
||||||
 PTFE g |
10 | |||||
 PTFE b |
||||||
| PTFE g |
 FKM |
-20 | +200 | 10 | 600 (60) | |
| PTFE b |
||||||
 UHMWPE |
NBR |
-30 | +90 | 5 | 400 (40) | |
| MVQ |
-60 | |||||
| Ordering example | |
| Introduction | Rod seal TS09-ES |
| d x D x L [mm] | 100 x 120 x 10 |
| Sealing material | XHPU/NBR |
Product classification
Label List
Previous Page
TS17-E
Next Page
Free inquiry
