| Surface roughness | Rtmax | Ra |
| Sliding surface | ≤ 2 µm | 0.05-0.3 µm |
| Groove bottom | ≤ 6.3 µm | ≤ 1.6 µm |
| Groove side | ≤ 15 µm | ≤ 3 µm |
| Bearing area: 50-95% and 0.5 Rz cutting depth (based on Cref = 0%) | ||
| Recommended Size mm | Maximum gap mm | |||||||||
| d/f8 | D/H10 | L/+0.2 | Rmax | C | OD | s* | ||||
| ＞ | ≤ | 100 bar | 200 bar | 400 bar | 600 bar |
|||||
| 4 | 8 | d + 4.9 | 2.2 | 0.4 | 2.5 | 1.78 | 0.30 | 0.20 | 0.15 | 0.05 |
| 8 | 19 | d+7.3 | 3.2 | 0.6 | 3.5 | 2.62 | 0.40 | 0.25 | 0.15 | 0.05 |
| 19 | 38 | d + 10.7 | 4.2 | 1.0 | 4.5 | 3.53 | 0.40 | 0.25 | 0.20 | 0.10 |
| 38 | 200 | d + 15.1 | 6.3 | 1.3 | 5.0 | 5.33 | 0.50 | 0.30 | 0.20 | 0.10 |
| 200 | 256 | d + 20.5 | 8.1 | 1.8 | 6.0 | 7.00 | 0.60 | 035 | 0.25 | 0.15 |
| 256 | 650 | d + 24.0 | 8.1 | 1.8 | 8.0 | 7.00 | 0.60 | 0.35 | 0.25 | 0.15 |
| 650 | 1000 | d + 27.3 | 9.5 | 2.5 | 10.0 | 8.40 | 0.70 | 0.50 | 0.30 | 0.20 |
| 1000 | 2000 | d+38.0 | 13.8 | 3.0 | 12.0 | 12.00 | 1.00 | 0.70 | 0.60 | 0.30 |
| The extrusion gap values shown in the table above are applicable to temperatures below 70 °C. Higher temperatures require lower extrusion gaps. | ||||||||||
| Operating parameters | ||||||
| Material | Temperature | Speed | Pressure | |||
| Sealing components | Elastomer | Minimum °C | Maximum °C | Maximum m/s | Maximum bar (MPa) | |
 PTFE g |
NBR70 | -30 | +100 | 10 | 600 (60) | |
 PTFE b |
||||||
 PTFE c |
FPM70 | -20 | +200 | |||
| Ordering example | |
| Introduction | Rod Seal TS09-D |
| d x D x L [mm] | 100 x 115.1 x 6.3 |
| Sealing material | PTFE b / NBR70 |
Product classification
Label List
Previous Page
TS09-DS
Next Page
Free inquiry
