| Surface roughness | Rtmax | Ra |
| Sliding surface | ≤ 2.5 µm | 0.1-0.5 µm |
| Groove bottom | ≤ 6.3 µm | ≤ 1.6 µm |
| Groove side | ≤ 15 µm | ≤ 3 µm |
| Bearing area: 50-95% and 0.5 Rz cutting depth (based on Cref = 0%) | ||
| Recommended Size mm | Maximum gap mm | ||||||||
| d/f8 | D/H10 | L/+0.2 | Rmax | C | OD | s* | |||
| ＞ | ≤ | 100 bar | 160 bar | 250 bar | |||||
| 4 | 8 | d + 4.9 | 2.2 | 0.4 | 2.5 | 1.78 | 0.30 | 0.25 | 0.20 |
| 8 | 19 | d+7.3 | 3.2 | 0.6 | 3.5 | 2.62 | 0.40 | 0.30 | 0.25 |
| 19 | 38 | d + 10.7 | 4.2 | 1.0 | 4.5 | 3.53 | 0.50 | 0.40 | 0.25 |
| 38 | 200 | d + 15.1 | 6.3 | 1.3 | 5.0 | 5.33 | 0.50 | 0.40 | 0.30 |
| 200 | 256 | d + 20.5 | 8.1 | 1.8 | 6.0 | 6.99 | 0.70 | 0.50 | 0.35 |
| 256 | 600 | d + 24.0 | 8.1 | 1.8 | 8.0 | 6.99 | 0.70 | 0.50 | 0.35 |
| The extrusion gap values shown in the table above are applicable to temperatures below 70°C. Higher temperatures require lower extrusion gaps. | |||||||||
| Operating parameters | ||||||
| Material | Temperature | Speed | Pressure | |||
| Sealing components | Elastomer | Minimum °C | Maximum °C | Maximum m/s | Maximum bar (MPa) | |
 PU |
NBR70 |
-30 | +100 | 1 | 250(25) | |
 HPU |
||||||
 SPU |
-30 | 1.4 | ||||
 TPU |
-30 | 1 | ||||
| Ordering example | |
| Introduction | Rod Seal TS09-P |
| d x D x L [mm] | 100 x 115.1 x 6.3 |
| Sealing material | PU/NBR70 |
Product classification
Label List
Previous Page
TS1012-T
Next Page
Free inquiry
