| Surface roughness | Rtmax | Ra |
| Sliding surface | ≤ 2.5 µm | 0.1-0.5 µm |
| Trough bottom | ≤ 6.3 µm | ≤ 1.6 µm |
| Trough side | ≤ 15 µm | ≤ 3 µm |
| Bearing area: 50-95% and 0.5 Rz cutting depth (based on Cref = 0%) | ||
| Recommended Size mm | Maximum gap mm | |||||
| d/f8 | D/H10 | L/+0.2 | Rmax | C | s* | |
| ＞ | ≤ | |||||
| 10 | 40 | d + 10 | 16 | 0.4 | 4 | 0.25 |
| 40 | 75 | d+15 | 25 | 0.4 | 5 | 0.38 |
| 75 | 150 | d + 20 | 32 | 0.4 | 6 | 0.50 |
| 150 | 200 | d + 25 | 40 | 0.4 | 8.5 | 0.63 |
| 200 | 300 | d + 30 | 50 | 0.4 | 10 | 0.75 |
| 300 | d + 40 | 63 | 0.4 | 13 | 1.00 | |
| The extrusion gap values shown in the table above apply to temperatures below 70°C. Higher temperatures require lower extrusion gaps. | ||||||
| Operating parameters | |||||||
| Material | Temperature | Speed | Pressure | ||||
Support ring TS13-T |
Sealing ring TS14-T |
Pressure ring TS15-T |
Minimum °C | Maximum °C | Maximum m/s | Maximum bar (MPa) | |
|
 PU |
|
-30 | +100 | 0.5 | 600(60) | |
 HPU |
-20 | ||||||
 SPU |
0.7 | ||||||
 TPU |
-40 | 0.5 | |||||
|
PU |
 XHPU |
-30 | ||||
| HPU |
XHPU |
-20 | |||||
| SPU |
XSPU |
0.7 | |||||
| Ordering example | |
| Introduction | Rod seal TS1315-T |
| d x D x L [mm] | 100 x 120 x 32 |
| Sealing material | POM/PU/POM |
Product classification
Label List
Previous Page
TS16-A
Next Page
Free inquiry
