| Surface roughness | Rtmax | Ra |
| Sliding surface | ≤ 2 µm | 0.05–0.3 µm |
| Trough bottom | ≤ 6.3 µm | ≤ 1.6 µm |
| Trough side | ≤ 15 µm | ≤ 3 µm |
| Bearing area: 50-95% and 0.5 Rz cutting depth (based on Cref = 0%) | ||
| Recommended Size mm | Maximum gap mm | |||||||||
| d/f8 | D/H10 | L/+0.2 | Rmax | C | s* | |||||
| ＞ | ≤ | 20 bar | 100 bar | 200 bar | 300 bar | 400 bar | ||||
| 5 | 18 | d + 4.5 | 3.6 | 0.4 | 2.0 | 0.25 | 0.12 | 0.10 | 0.08 | 0.07 |
| 25 | 50 | d + 6.2 | 4.8 | 0.4 | 3.0 | 0.35 | 0.17 | 0.12 | 0.10 | 0.08 |
| 50 | 120 | d + 9.4 | 7.1 | 0.4 | 4.0 | 0.45 | 0.22 | 0.17 | 0.12 | 0.10 |
| 120 | 630 | d + 12.2 | 9.5 | 0.4 | 5.0 | 0.60 | 0.31 | 0.25 | 0.15 | 0.12 |
| 630 | 1600 | d + 19.0 | 15.0 | 0.4 | 6.0 | 0.87 | 0.48 | 0.38 | 0.28 | 0.20 |
| The extrusion gap values shown in the table above apply to temperatures below 70°C. Higher temperatures require lower extrusion gaps. | ||||||||||
| Operating parameters | ||||||
| Material | Temperature | Speed | Pressure | |||
| Sealing components | Elastomer | Minimum °C | Maximum °C | Maximum m/s | Maximum bar (MPa) | |
 PTFE v |
1,4310 | -200 | +260 | 15 | 200 (20) | |
 PTFE g |
400 (40) | |||||
 PTFE b |
||||||
 PTFE c |
||||||
 UHMWPE |
+90 | 200(20) | ||||
| Ordering example | |
| Introduction | Rod seal TS19-F |
| d x D x L [mm] | 100 x 109.4 x 7.1 |
| Sealing material | PTFE b |
Product classification
Label List
Previous Page
TS20-R
Next Page
Free inquiry
