| Surface roughness | Rtmax | Ra |
| Sliding surface | ≤ 2.5 µm | 0.1–0.5 µm |
| Groove bottom | ≤ 6.3 µm | ≤ 1.6 µm |
| Groove side | ≤ 15 µm | ≤ 3 µm |
| Bearing area: 50-95% and 0.5 Rz cutting depth (based on Cref = 0%) | ||
| Recommended Size mm | Maximum gap mm | |||||||
| d/f8 | D/H10 | L/+0.25 | Rmax | C | s* | |||
| ＞ | ≤ | ＞ | ≤ | |||||
| 11 | 100 | - | - | d + 4.36 | 4.5 | 0.4 | 2.0 | f8/H8 |
| 100 | 150 | 11 | 20 | d + 4.36 | 6.5 | 0.4 | 2.0 | f8/H8 |
| 150 | 250 | 20 | 40 | d + 6.00 | 7.4 | 0.4 | 3.0 | f8/H8 |
| 250 | 400 | 40 | 100 | d + 9.06 | 10.1 | 0.4 | 3.5 | f8/H8 |
| 400 | 600 | 100 | 300 | d + 11.88 | 12.8 | 0.4 | 4.5 | f8/H8 |
| 600 | 300 | 600 | d + 17 | 17.5 | 0.4 | 4.5 | f8/H8 | |
| The extrusion gap values shown in the table above apply to temperatures below 70°C. Higher temperatures require lower extrusion gaps. | ||||||||
| Operating parameters | ||||||
| Material | Temperature | Speed | Pressure | |||
| Sealing components | Elastomer | Minimum °C | Maximum °C | Maximum m/s | Maximum bar (MPa) | |
 NBR |
|
–30 | +100 |
0.5 | 700 (70) | |
 HNBR |
–25 | |||||
 FKM |
|
–20 | +200 | |||
| HNBR |
–25 | +150 | ||||
POM
PTFE g
PEEK| Ordering example | |
| Introduction | Rod seal TS20-R |
| d x D x L [mm] | 100 x 115 x 10 |
| Sealing material | NBR/POM |
Product classification
Label List
Previous Page
TS21-P
Next Page
Free inquiry
